GIN GTO 2 - Manual (Page 14)

14
TIP: If the glider comes up slightly
off-centre, make small corrections by
moving towards the lower side.
TIP: In stronger winds, be prepared
to take a couple of steps towards the
canopy as it inflates and rises.
TIP: Launch the GTO 2 with the inner ‘A’
risers. Hold either the actual lines or the
maillon and pull upwards in an arc, not
towards you.
TIP: Practice ground-handling regularly
to improve your take-off skills!
CAUTION: Groundhandling (especially
on rough surfaces) will accelerate the
ageing process of your wing.
Is the airspace and visibility clear?
Launching
The GTO 2 has smooth and progressive inflation characteristics with no tendency to hang back
or shoot forwards.
Forward launch (nil to light winds)
Lean forward positively and guide the ‘A’ risers smoothly upwards in an arc, keeping your
elbows bent and hands at the level of the shoulders. The GTO 2 will inflate easily—there is no
need to aggressively pull or push the risers. As the glider comes above your head, make sure that
the canopy is correctly inflated and that there are no knots or tangles in the lines. Check that the
airspace and visibility are clear. If everything is in order, move forward decisively off the take-off.
Reverse launch (light to strong winds)
Take the brakes and turn around to face the wing. Pass one set of risers over your head as you
turn. Make sure the lines are free from knots or tangles. Check that the airspace and visibility are
clear. Gently pull up the glider in an arc with the ‘A’ risers. When the glider is overhead, brake it
gently if necessary, turn around and launch.
Landing
Remember the following general points to make a good landing:
Observe the wind direction and strength, and any hazards in, or near, the landing area.
Fly a proper landing circuit and plan your final approach well in advance.
Actively choose a spot on the ground in the landing field to aim for. Adopt an upright position