Garelick 75016 UNIVERSAL BOAT SEAT SWIVELS - Manual

Mounting Instructions and Template for
Model 75019 Quick Release Track
Form 12.169
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
8/98
ASSEMBLY INFORMATION
1. Check parts against parts list.
2. Read Instructions completely before starting assembly.
3. NOTE: This product uses locknuts for a secure assembly.
Locknuts thread on harder than conventional nuts and
require a screwdriver and wrench for attachment.
TOOLS REQUIRED
1. Wrench adjustable to 7/16"
2. Screwdriver
3. Drill
TRACK MOUNTING INSTRUCTIONS
1. Position template on reverse side of Instruction sheet for
plastic tracks (A) on seat bench to locate securing points for
drilling. Mark end drill the six holes.
2. Position plastic tracks (A) as shown in Fig. 1. Use bolts or
screws best suited for your boat to secure tracks.
TO ADAPT MODEL 75018 SWIVEL FOR USE WITH
MODEL 75019 QUICK RELEASE TRACK SYSTEM
1. Place spring (B) on locking handle (C) as illustrated in Fig. 2.
2. Slide locking handle with attached spring over end of
model 75018 swivel as indicated in Fig. 3. The end of the
swivel must be sandwiched between the spring and the
locking handle as Illustrated.
3. Align holes of locking handle, swivel end and spring; then
insert screw (D) through them as illustrated in Fig. 3. Slip
bushing (E) and washer (F) over threads of screw (D).
Secure bushing end washer onto screw with nut (G).
Finger tighten only.
(over)
FIG. 2
FIG. 3
FIG. 1
Parts List
Ref. Factory No.
Letter Part No. Req. Description
A 06.096 2 Plastic track
B 49.111 1 Spring
C 59.038 1 Locking handle
D 03.174 1 1 ⁄
4
-20 x 3 ⁄
4
" machine screw
E 08.020 1 Bushing
F 03.125 1 Washer
G 03.017 1 1 ⁄
4
-20 locknut