Garelick 75082 SEAT SLIDE AND SWIVEL - Manual

Assembly and Installation Instructions for
Seat Slides
Form 12.213
ASSEMBLY INFORMATION
1. Read instructions completely before starting assembly.
NOTE: This product comes in two separate cartons. One
contains the seat cushions; the seat base is in the other.
ASSEMBLY INSTRUCTIONS
Refer to Fig. 1
1. Position your spider on the slideplate (A) so the spider’s
knob (B) will be opposite the locking hole (C).
2. Align the 4 slotted holes in both the spider casting and the
slideplate, insert screws (D) through the slideplate and the
spider casting. Secure in position with washers (E) and
locknuts (F).
Refer to Fig. 2A or 2B
1. Position the trackplate (B) on your seat’s bottom.
2. Align the holes in both the seat and trackplate. Secure the
trackplate to your seat with appropriate hardware.
NOTE: Fastener Suggestion is illustrated. Mounting
hardware is provided with some slide models.
NOTE: All EEZ-In seats use 1 ⁄
4
"-20 threaded T-nuts.
SPECIAL NOTE: When attaching a slide to an EEZ-In
rotational molded seat:
A. Remove the reinforcement brackets from the seat
bottom prior to installation.
B. Make certain that the portion of the screw entering
the seat shell’s T-nut does not exceed 3/8". Seat
shell T-nuts are 1 ⁄
4
"-20 thread. Use only 1 ⁄
4
"-20
machine screws.
Refer to Fig. 3
1. Pull the packing tape off the trackplate’s locking nut (H) and
align the holes in the nut and poly sleeve if necessary.
2. Slip the slideplate (A) onto the trackplate (G) as shown.
3. Align the holes in the locking nut and sideplate. Slip the
stainless steel washers (I) and the poly washer (J) onto the
locking knob (K). Insert the locking knob into the slide
plate’s hole and thread it into the locking nut. Secure the
slide in position.
FIG. 1
FIG. 3
FIG. 2B
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: [email protected]
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
12/01
TO OPERATE
Loosen the locking handle and slide your chair to the desired
position. Tighten the handle to secure the slide in place.
CARE AND MAINTENANCE
1. Periodically check all fasteners to insure that they are
secure.
2. If necessary, lubricate your slide and spider with a suitable
marine grade grease for longevity and smooth operation.
FIG. 2A