Garelick 22000 SEAT SLIDE SYSTEM User Manual
Page 2
(continued)
SMOOTH DELRIN CUP INSTALLATION FOR ADJUSTABLE
HEIGHT SEAT BASES MODELS 75436/75437
Refer to Fig. 3.
1. Align 2 of the 3 countersunk holes in the Delrin cup
(59.858) as shown in figure 3. This will allow clearance of
the screws and nuts with the ribs on the inside wall of the
stanchion. Mark the 2 locations and remove the cup.
2. Center punch the 2 marks. With a 13/64" bit, drill 2 holes
through.
3. Fasten cup in place using 2 flat head screws (03.547) and
2 locknuts (03.027).
NOTE:
After assembly and installation of the seat is
complete, check to see if the seat will lock in the forward
facing position. If the seat locks slightly left or right of
perfectly forward, it may be necessary to rotate the base
slightly to achieve the ability to lock your seat straight
forward.
TO OPERATE
1. To adjust fore and aft seat position, pull up on Handle “A”,
slide seat to desired position and release handle. Slide will
lock into position.
2. To rotate seat and adjust the drag control feature for
rotation, pull Handle “B” up to the horizontal position and
release. The handle will maintain the horizontal position.
The seat is now free to rotate 360 degrees. To increase the
drag on rotation, turn Handle “C” clockwise to desired
resistance. To decrease drag, turn Handle “C” counter-
clockwise.
3. To positive lock the rotational feature, push Handle
“B”down and the Positive Quick Lock feature hunts for the
next available locking spline.
NOTE: Always use positive lock feature when boat is
underway.
MAINTENANCE
Keep a light film of grease on:
– Slide plate surface that the casting slides on
– The multiple cam surfaces that the casting locks into
– The Cam Surface on the Bottom of Handle “B” that is
exposed when in the horizontal position
– The Stainless Steel bolt that Handle “C” is threaded onto
Periodically check and tighten the mounting screws between the
seat slide and the seat bottom.
Installation and Operating Instructions –
Model 20000/20001/21000/21001/22000 Seat Slide System
Form 12.331
FIG. 3