Garelick 75013 SEAT HINGES - Manual (Page 2)

Mounting Instructions –
Side Mount Helmsman Seat Hardware with H-leg; Model 75014
Form 12.119
(continued from other side)
7. Attach the 2 U-mounting brackets (A) to support brackets
(B) by aligning their holes and inserting bolts (F) as in Fig.
3. Secure with locknuts (G). Finger-tighten only. These nuts
will have to be removed in step 9.
8. Position the attached U-mounting brackets (A) against the
line drawn in step 1. Mark the bracket’s hole locations on
the side bulkhead and drill all 4 holes with a 1/8" bit (see
Fig. 3).
9. Remove the 2 U-mounting brackets from the support
brackets and align them with the drilled holes on the side
bulkhead. Secure with 4 screws (C).
10. Attach seat to boat by aligning support bracket’s and U-
mounting bracket’s holes, inserting bolts (F) and securing
with locknuts (G) as in Fig. 3.
11. Insert the grooved ends of H-leg (E) into both socket
castings mounted on seat. Check to see that seat bottom is
parallel to deck surface (see Fig. 4). If not, cut off the
appropriate length of tubing on opposite end with a
hacksaw. Slip polytips (H) on ends of H-leg.
NOTE: Tips will go on easier by heating in warm water.
12. If fore and aft adjustment of seat is desired, then seat may
be adapted by using model 75005 Side Sliding Assembly.
MOUNTING INSTRUCTIONS FOR MODEL 75014
1. Follow steps 5, 6 and 11 of the above instructions for
mounting. NOTE: Screws (C) not provided.
FIG. 4 FIG. 3