Garelick 75008 Side Slide with Mounting Hardware - Manual (Page 2)

Mounting Instructions –
Model 75005 Side Slide and Model 75008 Side Slide with Mounting Hardware
Form 12.118
3. After choosing the side to be mounted, refer to fig. 3 and
position both support brackets on the bottom of the seat so that:
a) All screw holes are located on the seat bottom.
b) Brackets are centered on the seat bottom for maximum
support.
c) Seat will be positioned far enough away from slide so that
seat will not interfere with slide travel and folding action.
NOTE: It is allowable to mount support brackets over the
hinge on the seat bottom for correct positioning.
4. Mark the bracket’s hole locations on the seat bottom and drill all
with a 1/8” bit.
5. Remove the two support brackets from the U-mounting brackets
and align them with the drilled holes on the seat bottom. Secure
them to the seat bottom using screws (I).
6. Position socket casting (J) on the seat bottom so it is centered on
the seat’s side and at least 1” from the edge. Make sure that the
flat side of socket faces towards the mounted support brackets
(see fig. 3). Mark the socket’s 4 holes and drill them with a 1/8”
bit. Secure the casting in position with 4 screws (I).
7. Attach slide assembly (A) to the side bulkhead of boat by
following steps 1,2 & 3 for the 75005 Slide Assembly above.
8. Attach seat to slide by aligning support bracket’s and
U-mounting bracket’s holes, inserting bolts (G) and securing with
locknuts (H).
9. Insert the grooved end of stanchion leg (K) into socket casting
mounted on seat. Check to see that bottom is parallel to deck
surface. If not, cut off the appropriate length of tubing on
opposite end with a hacksaw. Slip poly tip (L) on end of
stanchion leg. NOTE: Tip will go on more easily if first heated in
warm water.
FIG. 3