Galaxy Audio RM2 - Manual (Page 13)

l Radio Station Memory Function.
20 Station Presets available (10 AM / 10 FM).
Stations may be preset to memory by using either of the following two
methods:
1.) Tune in desired station. Press “ 7 “ (MEMORY), then press the desired
memory location “ 3 ” (M1-M5), and then press “ 7 “ (MEMORY) once
more. Repeat for additional station presets. To preset memory locations
M6 thru M10 press “ 7 “ (MEMORY), then press “11” (M+5). Then press
the desired memory location “ 3 ” (M1-M5), and then press “ 7 “
(MEMORY) once more. Repeat for additional station presets.
2.) Tune in desired station. Press “ 7 “ (MEMORY), then press “5” (MEM
UP) until the desired memory location (M1-M10) is selected, and then
press “ 7 “ (MEMORY) once more. Repeat for additional station presets.
To recall and play preset stations M1-M5 simply press the corresponding
button. To recall and play preset stations M6-M10, press “11” (M+5), and
then press one of the M1-M5 buttons. Alternatively, you may simply step
through the presets by pressing “5” (MEM UP) until you reach the desired
station.
l Sleep Function
This function allows the tuner to play a station for a preset amount of time,
and then switch off the tuner when the time expires. Press “10 “ (SLEEP) to
activate this function. “90” will appear in the display to indicate the tuner will
play for 90 minutes. Press “SLEEP” repeatedly to change the play time.
The time will step down, from 90 to 10 minutes, in 10-minute steps. When
the desired time is reached wait for the display to return to the play mode.
“SLEEP” will be shown in the display to indicate this function is active. This
function may be cancelled at any time by simply pressing “SLEEP” once.
l LEVEL (VOLUME)
Rotate “ 4 “ (LEVEL) to adjust & control the desired volume.