Cabletron Systems 5500 - Manual (Page 75)

Device Application View
Discovery Application
Application View Cisco Catalyst 5000/5500 Hub
5-18 Management Module Guide
Figure 5-4. Add/Remove Buttons
Changing a PortÕs VLAN
To select a VLAN to add a port to, highlight the VLAN number icon in the
VLAN panel. Double click on the port icon which you would like to add to the
VLAN. The port icon will be highlighted to indicate the change. The port
counts, next to the VLAN icons, should accurately reßect the number of ports
assigned to each VLAN.
Removing a VLAN
To remove a VLAN, make sure there are no ports assigned to the VLAN.
Highlight that VLANÕs number icon. Click the ÒRemoveÓ button. The VLAN
will be removed from the VLAN panel.
Discovery Application
This section describes the Discovery Application supported by the cisco
Catalyst Hub. The model type name for this application is CiscoCDPApp.
Table 5-5 describes each of the application-speciÞc Icon Subviews menu
selections available for the Discovery Application.
Remove Add
VLAN : 3
Table 5-5. Catalyst Stack Application-SpeciÞc Icon Subviews Menu Selections
Menu Selection Description
Cache Opens the Discovery Cache Table view, described later in
this chapter.
Interfaces Opens the Interface Discovery Status Table view, described
later in this chapter.
Model Information View Opens the Model Information view described in the
SPECTRUM Views reference.