Flyzone HCAA27 - Manual (Page 5)

5
❏ 7. From the right side of the fi n holder install two
2mm x 8mm machine screws. Tighten the screws
until the fi n fi ts snug in the fi n holder. Be careful
not to overtighten the screws.
❏ 8. Remove the pushrod retainers from the
pushrod wires. Slide the wire into the outermost
hole in both the rudder and elevators’ control
horns, and then re-install the pushrod retainers.
INSTALL THE LANDING GEAR
❏ 1. Slide the tail wheel wire into the slot on the
bottom of the fuselage.
❏ 2. Place the plastic tail wheel retainer over the
landing gear slot. Secure it to the fuselage with
2mm x 5mm sheet metal screws.