Install the wing joiner, Check the radio system – Flyzone FLZA3014 User Manual

Page 8

Install the Wing Joiner

❏

1. Holding the left wing half upright, carefully insert the wing

joiner into the wing half until the wing bolt hole in the joiner
aligns with the wing bolt hole in the wing.

❏

2. Insert the wing joiner in the right wing. Route the aileron

servo wires out the bottom of the wing.

❏

3. Insert the plastic wing connector in the top of the wing.

Note that the connector is angled to match the angle of the
top of the wing. When correctly installed, the connector should
be fl ush with the top of the wing.

Check the Radio System

CAUTION: Do not install the propeller on the plane until
instructed to do so.

❏

1. If using the Tactic TTX600 radio system read the Radio

System Instructions section on page 16 in this manual. Then,

install the four AA alkaline batteries in the transmitter with
the correct polarity.

DOWN

❏

2. Check that the servo reversing switches are confi gured

as shown.

This manual is related to the following products:

FLZA3010