Flyzone FLZA2052 - Manual (Page 10)

10
Take off (or hand launch) heading into the wind.
The Micro S.E.5a will take off with ease at just 1/2-throttle
and 3/4-up elevator throw.
Once in the air, gain altitude to allow yourself sufficient
reaction time to make a correction during flight. Once you’re
comfortable, adjust the rudder and elevator trims one click
at a time so that the Micro S.E.5a flies straight and level
with the control sticks centered.
Concentrate on brief control stick inputs of rudder so that
the Micro S.E.5a turns without causing the aircraft to roll
abruptly. A slight amount of up elevator may be necessary
to maintain altitude going into a turn and the elevator will
need to be returned to neutral when coming out of a turn
to avoid gaining altitude.
It’s recommended that you attempt to land before the motor cuts out due to low voltage. Attempt to land into the
wind by pitching the elevator up, slowing the descent and reducing the glide slope. Gradually reduce the throttle and
just before touchdown apply some up elevator to land safely on the landing gear and tail skid. Disconnect the battery
from the model, then switch off the transmitter. Allow the motor to cool between flights.
If anytime during operation the controls or propeller become jammed or unresponsive, lower the power to the propeller,
and land. Disconnect, then reconnect the LiPo on the Micro S.E.5a to attempt to regain control.
FLYING THE MICRO S.E.5A
With the transmitter powered and the battery plugged into the Micro S.E.5a, walk 50 ft [15m] from the aircraft and
check the control functions for proper and smooth operation.
RANGE CHECK
50 ft [15m]