Expert Sleepers Silent Way v1.7.3 - Manual (Page 68)

1.1.0 29/7/2009
• The Voice Controller AU now has an effect variant so it will work in Digital Per-
former.
• Added new OSC commands (registerOSCPathForParameter() and registerOSCPath-
ForParameterNormalized()) added, primarily for compatibility with TouchOSC.
• Output configuration changed from a set of drop-down menus to a full matrix of
knobs.
• Envelope scale parameters removed, since the same functionality is now offered by
the output matrix.
• Added new 'velocity' output.
• Added velocity-based scaling of envelopes.
• Added Hz/V calibration mode.
• Areas of the full MIDI note range note covered during calibration are now filled with
‘wrapped around’ values from octaves that are covered.
• Added note priority modes (last/low/high) and retrigger modes (on/off).
• Added ‘panic’ button.
• Fixed some incorrect envelope triggering behaviours.
• The ‘trigger’ output is now slightly longer than before (it was previously a single
audio sample).
NB v1.1.0 is not preset-compatible with earlier versions.
1.0.2 3/7/2009
• The Voice Controller VST plug-ins are no longer virtual instruments, they are effects.
This allows Cubase to handle them properly.
1.0.1 30/6/2009
• The Voice Controller AU now defines 3 stereo busses rather than 1 6 channel bus,
which allows Logic to handle it properly.
1.0.0 29/6/2009
• First release.
!