Mac 10, Ledc, 4x4 fan filter unit – Envirco MAC 10 LE-DC User Manual
Page 3: Critical operation conditions of the mac 10, Part numbers covered by this manual

MAC 10
®
LEDC
4x4 Fan Filter Unit
3
Innovators in Clean Air Technology | www.envirco.com | Operation & Maintenance
I n s t a l l a t i o n & S e r v i c e M a n u a l
■
Critical Operation Conditions of the MAC 10
1. Touching of the HEPA filter will damage it, voiding the warranty on the filter. The screen is only to protect against an
accidental ‘touch’ of the filter. Never place a hand or tool on the filter. Never lie filter face flat down on a surface always
have filter on its side to protect from damage.
2. Prior to powering the unit, verify that the unit has been wired into the correct voltage. The serial number label on the top
of the Mac 10 unit has the required voltage.
3. To insure you order the proper replacement parts or complete MAC 10 unit, record the part number and serial number.
This information is located on the serial number label, located adjacent to the electrical box. If you can’t locate the Sales
Order Number, please contact Envirco for this information.
■
Part Numbers Covered by this Manual
11185-XXX
MAC 10 LEDC 4x4
Standard Filter
11233-XXX
MAC 10 LEDC 4x4
RSR Filter
11233-Z XXX
MAC 10 LEDC 4x4
RSRE Filter
Note: A ‘Z’ in the part number indicates that the unit is special.
This may indicate a size change from standard or a special filter.
Please contact the factory for part numbers if this is the situation.
Units come set in manual mode from
the factory. Please review installation
requirements and set up with your end user
(See page 8 for complete set up instructions).