Emerson Radio DTE321 - Manual (Page 7)

6
GETTING STARTED
AC CONNECTION
Insert the small end of the AC adapter into
the DC IN jack on the side of the unit. Insert
the other end (with the 2 blades) into a
conveniently located AC outlet having 120
VAC, 60Hz.
NOTES:
• Use the enclosed AC adapter for this
product only.
• Remove both DC plug and AC-IN plug to
disconnect the AC adapter when not
using.
BATTERY PACK
The battery pack cannot be removed, it is built into the unit.
BATTERY INDICATOR
When using the rechargeable battery, the LOW BATTERY indicator will blink when the
battery pack is low and needs recharging. When it blinks, you have approximately five
minutes of playing time left.
CHARGING THE BATTERY PACK
Insert the small end of the AC adapter into the DC IN jack on the side of the unit and
turn the unit off for best results. Insert the other end (with the 2 blades) into a
conveniently located AC outlet having 120V AC, 60Hz. The CHARGING indicator will
light red as the battery is charging and the FULL indicator will light green when
charging has completed. Disconnect the AC adapter plugs when the charging has
finished.
NOTES:
• Fully charge the built-in NiMH battery pack (10-15 hours) before using it for the first
time.
• It is highly recommended to turn the unit off when recharging the batteries.
• This Ni-MH rechargeable battery will not be fully charged the first time, so the
discharging time will be short. The battery will take a full charge after four to five
times of charging or discharging.
• After a period of storage or if not used for a period, repeat the above mentioned
steps to get the battery back to normal charging condition.
THIS UNIT CONTAINS NIMH BATTERY PACK; DISPOSE THIS UNIT PROPERLY.