EDCO MS-20 - Manual (Page 14)

Printed in USA
©2002
Page 14
E-MS-GMS14&20-I-1002
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Clean and Lubricate Wheels on Rolling Table and
Pivot Points on Front Treadle:
• During daily visual inspection, check to be sure the wheels on the
rolling table move smoothly and that there is no debris in the wheel
groove. (Figure 26)
• Lubricate the wheels as necessary.
• Replace damaged or worn wheels.
Inspect and Clean Air Filter:
(FIgure 25 shows Honda Cyclone Dual Filter style element).
• Refer to the Engine Manufacturer’s Owner’s Manual for instructions
on specific models.
• Check air filter at least once daily.
• Dirt build up on the filter will cause excessive engine wear.
Change Engine Oil:
• Check Engine Oil before each operation. Open the filler cap and look
at the dip stick. (Figure 24) Oil should be clearly visable both on the
stick and in the cavity and should look fairly clean. Running the
machine on dirty oil or when the oil is low will result in damage to
the engine.
• Change the Engine Oil after every 50 hours of operation or sooner as
conditions require. Refer to the Engine Manufacturer’s Owner’s
Manual for specific viscosity recommendations and changing
instructions.
Grease Bearings:
• Drive shaft bearings must be greased every 4 hours.
(All are not visible in this photo)
Figure 26
Figure 23
Figure 25
Figure 24
Dip Stick
Grease Fittings