EDCO MS-20 - Manual (Page 11)

Printed in USA
©2002
Page 11
E-MS-GMS14&20-I-1002
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Cutting:
• Do not strain the engine/motor while cutting. Do not jam work piece into the blade. Do not twist the work piece while
cutting.
• When you have finished cutting:
On gasoline models: To stop engine, return throttle to idle. Stop the engine by turning the engine mounted stop
switch to the OFF position. Do not leave the saw running unattended.
On electric models: Depress the stop botton on the motor starter box. Wait until saw comes to a complete stop
before performing any type maintenance.
• Clean dust and debris from machine.
IMPORTANT:
• When actually cutting masonry products, it is important that the blade is at it’s maximum RPM. DO NOT force or
jam the blade. Forcing the blade will cause the motor to overheat, tripping the overload device or severe motor
damage.
• Do not reach underneath or around work piece while the blade is rotating.
• Keep stable footing at all times while cutting.
• Keep hair, clothing, fingers and all body parts away from the blade and any other
moving parts.
Arbor Shaft
Rating
Diameter
Blade
Max.
Cutting Depth
MS-14
GMS-14
MS-20
GMS-20
Model
2600 RPM
2600 RPM
2400 RPM
2400 RPM
14 inches
14 inches
20 inches
20 inches
5 inches
5 inches
8 inches
8 inches
Figure 17