For use with quick-change multi-accessory disc – EDCO SEC-NG-1.5 User Manual

Page 14

E-SECNG-I-0714

301-638-3326 • edcoinc.com • [email protected]

EQUIPMENT DEVELOPMENT COMPANY

FOR USE WITH QUICK-CHANGE MULTI-ACCESSORY DISC

PCDyma-SERTS

Makes quick work of epoxy coatings and hard glue - Ideal
for the removal of hard and tacky surfaces including ure-
thane epoxy, multi part epoxy, waterproofing membrane,
pool deck coating, thick membrane, thick mastics, old and
new epoxy coatings.
4 times stronger then carbide with incredible removal ca-
pabilities.

Dyma-SERTS

Grind 5 times faster than grinding stones and lasts longer -
up to 30,000 sq ft (2,800 sq m) of grinding action on standard
3,500 PDI concrete. Dyma-Serts can be used for wet or dry
grinding.

Ideal for the removal or Smoothing of rough surfaces or
trowel marks, grinding terrazzo, repairing surface damage to
concrete slabs, removing urethane or epoxy thincoats, grind-
ing sharp aggregates such as flint and granite, removing sur-
face imperfections from epoxy mortars, leveling high spots,
removing thin mastics and thin-set

5 times faster than grinding stones. Long Lasting!

Rotate the Dyma-SERTS

only, not the case.

STRIP-SERTS

Carbide tipped blocks are designed to clean floors without
grinding into the concrete. STRIP-SERTS

have a replace-

able, multi-sided tungsten carbide edge that can be rotated
for maximum use.

Removes surface build-ups without

grinding into the surface below

Ideal for the removal of Removing mastics, paints, resins,
tar, fiberglass, ice and industrial buildups.

Use a hex wrench to remove hex screw to allow rotation of
blade. Rotate this blade to expose a new cutting surface.
There are four cutting surfaces on each blade.

Accessory Case
DYMA-Sert
Spring Clip

Hex Screw
STRIP-Sert