EcoTech Marine Full EcoSmart - Manual (Page 39)

39 Section 6.4
Maintenance
Full Driver Memory Clear
In order to clear out a saved wave you must perform a full memory clear on the master driver. Dif-
ferent from the normal memory clear, a full driver memory clear will any and all configured settings
(i.e. feed mode time, battery backup speed, etc) and restore them to the original default settings.
In order to do this, follow the steps below.
HOLD Mode + Set HOLD Mode
*After holding Mode and Option
the driver will reset and the pump
will restart.
HOLD Mode & Option
*After you hotd Mode and Set
your control dial will blink red/
white/blue.
*After holding Mode your control
dial will blink red/purple.