DLE 222 User Manual
Page 6
6
3. Connect the ignition kill switch leads to the red connector from
the ignition control module using the lead from the kill switch or
with the included three pin connector with pig tail. Use the included
three pin securing clips to secure the connections.
4. Connect the ignition module batteries to the kill switches. Any
two 4.8-6.0V, 1000mAh and above capacity batteries will work well
for this. Use heat shrink tubing to secure this connection.
5. Install the silicone ignition
wire covers over the ignition
wires.
6. Install the spark plugs into
the engine cylinders (7-8lbs
Torque).
7. Use the following pictures and diagrams to install the Electronic
Ignition Modules to the engine.
8. Install both ignition kill
switches on the aircraft so
that they are easily accessible
from the outside of the plane.
9. Install the ignition
modules securely in the
airplane forward area. It is
recommended that a thin
piece of foam rubber is placed