beautypg.com

Installation instructions – DLE 222 User Manual

Page 5

background image

5

To avoid permanent damage to the electronic ignition systems,

NEVER rotate the propeller on your DLE engine with either of
the electronic ignition systems switched on and the plugs not
installed in the plug caps.

If you elect to not use a smoke system with your engine and

aircraft, the two included brass fi ttings must be installed in the
muffl er and then obstructed to prevent exhaust from leaking
into the cowling. To do this use two short segments of neoprene
fuel line and two (GPMQ4166) fuel-line plugs (not included).

Installation Instructions

Prepare the Engine for Installation

1. Check to see that all screws and bolts are tight. Check carefully for

any cracks, broken or missing parts. Tighten or replace any damaged
or missing parts before proceeding.

2. Install the silicone wire covers over the ignition pick up sensor
leads coming from the engine (cut the excess silicon wire covers)
and connect the leads to the pick up sensor leads from the Electronic
Ignition Modules. Secure the connections with the included three
pin connector securing clips.