Dangerous Music Source - Manual (Page 15)

Set the rate (In this case auditioning a CD).
(PHOTO OP 09)
44100Hz selected
(PHOTO OP 10)
To select the USB card if you have multiple devices,
open the Windows control panel.
(PHOTO OP 11)
Select ‘Sounds and Devices’.
(PHOTO OP 12)
Select the XMOS USB Audio 2.0 device.
(PHOTO OP 13)
Play audio for one second so the USB card learns the
sample rate and clocking information.
You are ready to rock.
Note: If you change the sample rate, you have to give the USB card a 1 second burst of “Play”
again so it can adjust itself to the new condition.
Windows 8 is supposed to implement a USB Audio 2.0 system. The engineers at Dangerous chose Audio 2.0 because it runs
higher sample and bit rates. PC users, welcome to the bleeding edge!
PHOTO OP 09
PHOTO OP 11
PHOTO OP 10
PHOTO OP 12
PHOTO OP 13
SOURCE | 11