Dangerous Music Source - Manual (Page 11)

SOURCE | 7
5. SPEAKER SOURCE SETUP (TOGGLE TO LATCH MODE)
[
speaker source buttons pictured above
]
Feature: Set the desired behavior for the
speaker source buttons
: either
toggle
or
latch
mode.
Benefit: Simultaneously press and hold the bracketed
setup
buttons (
an 2
and
aes / spdif
) on the
headphone source
side. The
setup
lights
will blink. Then press the button with the orange circle (
an 1
) on the
speaker source
side to switch between
toggle
mode (button unlit) and
latch
mode (button lit). Press either of the blinking
setup buttons
(
an 2
or
aes / spdif
) to store and
exit setup mode.
6. SPEAKER SELECTION (TOGGLE OR LATCH MODE)
[
speaker selection buttons pictured above
]
TOGGLE
Feature: Instantly and silently switch between your speakers using the
speaker selection buttons
(
spkr 1
and
spkr 2
) auditioning
only one set of monitors at a time.
Benefit: A/B tracking and mix decisions between two different sets of speakers.
Note:
This is the default setup.
LATCH
Feature: Silently select or deselect any combination of 1 and/or 2 speakers (i.e.
spkr 1
and
spkr 2
).
Benefit: Audition through either set of speakers or both simultaneously (ie. for the control room and live room).
Tip:
,
Use one output for speakers and the other output for a sub (not the sandwich): turn the sub on or off whenever you
need it. (Also, always hear the speakers in full range- some subs have a non bypassable crossover.)
7. SPEAKER SELECTION (TOGGLE TO LATCH MODE)
[
speaker selection buttons pictured above
]
Feature: Set the desired behavior for the
speaker selection buttons
.