D.A.S. Audio Energy Series - Manual (Page 25)

9
APPENDIX C. Heat emission and current draw tables
Consumos eléctricos (A) / Power consumtion (A)
Modelo / Model
Modelo / Model
Max 1/3 1/8 Sin señal / Idle
Max 1/3 1/8 Sin señal / Idle
Emisión de Calor (BTU/h-kcal/h) / Heat Emission (BTU/h-kcal/h)
E-8T 70 V or 100 V 5,6 1,7 0,7 0,3
E-12T 70 V or 100 V 7,7 2,4 0,9 0,4
E-8T 70 V or 100 V 1380 / 350 445 / 110 235 / 60 210 / 55
E-12T 70 V or 100 V 1795 / 450 510 / 130 235 / 60 210 / 55
APPENDIX D. Troubleshooting
The fuse blows, take the unit to a service centre.
The Power LED indicator lights up and the rest of LEDs
do not. The thermal protection of the transformer is working.
Allow the amplifier to cool down. The cause might be
prolonged overloading.
The protection LEDs light up permanently. The amplifier might have suffered a momentary
overloading. Turn Off the amplifier, wait a few minutes
and turn it On again.
Check that there isn’t any short circuit in the wires or
the speakers.
Unplug the loads, turn the amplifier Off and, after waiting
a few minutes, turn it On again. If the amplifier does not
work properly take the unit to a service centre.
“Power ON” LEDs light up but the “Signal” LEDs do not.
One or two Clip LEDs light up with no signal.
Excessive ‘Hum’. All the electronic equipments must be connected to the
same earth connection. Check all the wires for faulty
shielding. Balanced lines are highly advisable. If posssible do
not connect the sound equipment to the same mains phase
as lights’ equipment. Prevent signal wires from running close
to electromagnetic sources like lighting equipment and
others.
Carga / Load
Carga / Load
Potencia de salida / Output Power
Potencia de salida / Output Power
The Power Switch is in the On position but the Power
LED indicators do not light up.
Check the signal cable and replace if defective.
Check the loads for a short circuit in the cables or the
speakers.
EN
Manual del Usuario User’s Manual / energy /