D.A.S. Audio Convert 15A series User Manual

Page 7

Manual del Usuario

/ convert

15A

series / User’s Manual

Remote monitoring is provided by way of the

monitoring system and software, an audio management
application for

powered cabinets and processors.

The

software offers users instant and intuitive

control over a range of parameters of a single cabinet or
processor via USB, or a network of them via RS485.

The wide frequency range and impressive output of

the

convert 15A is possible thanks to the D.A.S. built

transducer components. For the high impact, low
frequency reproduction required in a system of this level,
D.A.S. employs the

15GNR loudspeaker, a 15” device

incorporating a 102 mm (4”) edge-wound voice coil and a
light-weight neodymium magnet assembly

Three

M-60N neodymium compression drivers are

used to handle high frequency reproduction. The drivers
employ a 44 mm (1.75") voice coil made using copper
clad aluminum flat wire bonded to a urea polyamide
diaphragm. This high performance thermoplastic,
improves sensitivity and acoustic output as well as timbre.
The M-60N units are attached to the new

BPS-320

dSerpis trifunctional waveguide.

The new generation of Serpis waveguide technology is

exhibited in the extraordinary design of the

. Producing a time-aligned, phase coherent 20º

wave front, the

maximizes the combined

output of the three

M-60N drivers. When used in tight-

packed horizontal or vertical curved source arrays, the

provides extremely tight pattern control

with minimal interaction between horns.

As a point source, the drivers receive the

DCD

processed signal widening the curvature of the wavefront
to 40º. This permits the

convert 15A to be used as a single

cabinet or pairs of cabinets delivering the required
coverage to a broader area.

The

convert 15A enclosure is constructed using birch

plywood and finished with the ISO-flex black paint
providing excellent protection and durability. The 20º
trapezoidal shape of the

convert 15A enclosure allows for

tightly packed arrays with minimal high frequency
interaction. As an aid when stacking the enclosures in
vertical arrays, rubber locators on the side panels match
with fitting points on the surfaces of adjacent cabinets
preventing slippage.

The optional

InterLox rigging system can be used to

quickly and safely assemble tight-packed vertical or
horizontal curved-source arrays. M-10 threaded rigging
points are provided for use in permanent installation (for
more information see Rigging Manual).

DASnet

D.A.S.

DASnet

BPS-320

dSerpis

BPS-320 dSerpis

20º

40º

convert 1560A

Vertical dispersions according the model

Horizontal dispersions according DCD

convert 1590A

30º

45º