D.A.S. Audio Convert 15A series - Manual (Page 14)

Manual del Usuario / convert 15A series / User’s Manual
CHANGE OF CONFIGURATION
The unit has default settings from the factory. We can change some
default set parameters. The firmware described here is version 2.60.
TM However, parameters such as gain and delay can be changed only by DASnet .
As indicated on the back label of the unit to unlock, press and hold 'OK' for 2 seconds, until the arrows
cover the entire screen and then we can access the treble gain menu, or high-pass filter menu, etc, to make
changes.
, convert 1560A or convert 1590A,
From factory, the unit convert 1560A has default settings:
While the unit convert 1590A has default settings:
If we press and hold ‘OK’ for 2 seconds, until the arrows cover the
entire screen,
We will access the menus to change the gain treble, or high-pass filter,
or others default parameters.
First shown on the screen:
And pressing the arrows indicated (right or left), you can go to other
menus,
To access, simply click on ‘OK’. Thus, in the first menu, 'Configuration', we
can choose between the behavior of the unit as a point source (the default) or
curved source, simply by pressing the down arrow and click ‘OK’, or with up
arrow, to return to the previous menu.
As can be seen, by pressing the down arrow
on the last option, the menu returns to the first
option. This feature occurs in the other menus as
well.
TO UNLOCK,
PRESS AND HOLD OK
FOR 2 SECONDS
OK
OK
OK
14