Cabletron Systems SEHI-22/24 - Manual (Page 60)

Source Addressing
5-10 Configuring Source Address Traps
Figure 5-3. The Module Source Address Traps Window
To enable or disable port-level traps:
1. In the Port Source Address Traps window ( Figure 5-4 , page 5-11 ), click
mouse button 1 to select the port or ports for which you wish to enable or
disable traps. If the Set Trap Status For field displays
Selected Ports (the
default setting), you can click to select any ports; to de-select any highlighted
port, click on it again. If the selection
All Ports On Module is displayed in the
Set Traps Status For field, you can select only one port at a time; trap status
will be set for all ports on the same module as the selected port. If the
selection
All Ports on Repeater is displayed in the Set Trap Status For field,
all available ports will be automatically selected; if you de-select any port, the
Set Trap Status For field will automatically revert to the
Selected Ports
setting. To change the setting in the Set Trap Status For field, click mouse
button 1 on the currently displayed setting, and drag down to select a new
setting.