Comtrol RocketPort USB Modem Hub - Manual (Page 3)

FCC Notices 3 of 4
FCC Notices
Radio Frequency Interference (RFI) (FCC
15.105)
This equipment has been tested and found to comply
with the limits for Class A digital devices pursuant
to Part 15 of the FCC Rules.
This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try and correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or TV
technician for help.
Labeling Requirements (FCC 15.19)
This equipment complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
• This device may not cause harmful interference,
and
• This device must accept any interference
received, including interference that may cause
undesired operation.
Modifications (FCC 15.21)
Changes or modifications to this equipment not
expressly approved by Comtrol Corporation may void
the user’s authority to operate this equipment.
FCC Part 68 Notice
1.
This equipment complies with Part 68 of FCC
rules. On the bottom panel of the unit is a label
containing the FCC registration number, ringer
equivalence number, and the USOC jack code.
2. The RocketPort USB Modem Hub uses FCC
compliant modular plugs; it is designed to be
connected to the telephone network or premises
wiring using a compatible modular jack which is
FCC Part 68 compliant.
3. If this equipment causes harm to the telephone
network, the telephone company will notify you
in advance that temporary discontinuance of
service may be required. But, if advance notice is
not practical, the telephone company will notify
you as soon as possible. Also you will be advised
of your right to file a complaint with the FCC if
you believe it is necessary.
4. The telephone company may make changes in its
facilities, equipment, operations, or procedures
that could affect the operation of the equipment.
If this happens, the telephone company will
provide advance notice in order for you to make
necessary modifications in order to maintain
uninterrupted service.
5. If the equipment is causing harm to the network,
the telephone company may request you to
remove the equipment from the network until
the problem is resolved. If so, contact Comtrol
Corporation at 763-494-4100.
6. No repairs are to be made by you. Repairs are to
be made only by Comtrol or its licensees.
Unauthorized repairs void the warranty and the
registration.
7. This equipment may not be used for public coin
phone service provided by the Telephone
Company. Connection to Party Line Service is
subject to state tariffs. (Contact the state public
utility commission, public service commission, or
corporation commission for information.)
FCC Part 68 Yes
Canadian IC-03 Certification Yes
FCC Part 68 Certification Yes
Safety:
UL Listed
EN60950 Yes
Topic
Hardware
Specification
Baud rate (connect speed) 300 to 56 Kbps
Bus interface USB
Control by device driver:
Data bits
Parity
Stop bits
7 or 8
Odd, Even, None
1 or 2
Current consumption
(max):
4 modem & 2 USB 1.6 A
Dimensions 6” x 9” x 1.5”
DTE Speed Up to 600 - 115,200 bps
Heat output: <28 BTU/hr (max)
Mean time between failure 16.8 years
Number of modem ports 4
Number of downstream
self-powered USB ports
2
Power consumption < 8 W (max)
Power supply (max)
5V DC +/- 10% and
2 A
Ringer Equivalence
Number (REN)
0.1
Surge Protection
10 KV ESD (meets
standard part 68
telcom requirment)
Telcom connections RJ11C
Weight 1 lb 2 oz
Electromagnetic Compliance Status