CLEAR Spot 4G Apollo Users Guide - Manual (Page 14)

13
Manage your CLEAR Spot (continued)
CLEAR Spot Home Page / Wi-Fi Settings / Basic
Use this tab to view and change the basic wi-fi settings of your CLEAR Spot.
 Enable Wi-Fi: This setting is defaulted to “enable.” You may disable this setting if you only wish
to use the CLEAR Spot tethered to your computer. You will not be able to access the internet via
wi-fi with this setting disabled.
 Network Name (SSID): Shows the CLEAR Spot wi-fi network name (SSID), which is broadcast
by the CLEAR Spot, to allow wi-fi-enabled devices to identify and connect to it.
 Authentication: Select the wi-fi security type that is used by the CLEAR Spot. Use the wi-fi
security settings to password-protect access to your CLEAR Spot wi-fi network. WPA provides
the most robust level of wi-fi security, but older devices may not support it. WEP is supported by
virtually all wi-fi devices. Check your device’s user manual to find out which types of security are
supported.
 Encryption: Select the type of encryption that is used by the CLEAR Spot.
 Password Type: Select the type of password that is used by the CLEAR Spot.
 Password: View and change the password needed to access the CLEAR Spot’s wi-fi network.
Click “APPLY” when you’re ready to change the basic wi-fi settings.
If you don’t want to make any changes to the basic wi-fi settings, click “CANCEL”.
If you’re using your CLEAR Spot click
here to open the CLEAR Spot Home
Page.