beautypg.com

Operating your vehicle, Engine break-in recommendations, Turn signal/lights lever – Chrysler 2013 200 Convertible - User Guide User Manual

Page 21: Headlights/parking lights/automatic headlights

background image

ENGINE BREAK-IN RECOMMENDATIONS

• A long break-in period is not required for the engine and drivetrain (transmission and axle) in

your vehicle.

• Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 km),

speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.

• While cruising, brief full-throttle acceleration within the limits of local traffic laws contributes

to a good break-in. Wide-open throttle acceleration in low gear can be detrimental and should
be avoided.

• The engine oil installed in the engine at the factory is a high-quality energy conserving type

lubricant. Oil changes should be consistent with anticipated climate conditions under which
vehicle operations will occur. For the recommended viscosity and quality grades, refer to
“Maintaining Your Vehicle”.

NOTE:
A new engine may consume some oil during its first few thousand miles (kilometers) of opera-
tion. This should be considered a normal part of the break-in and not interpreted as an indica-
tion of difficulty.

CAUTION!

Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result.

TURN SIGNAL/LIGHTS LEVER

Headlights/Parking Lights/Automatic Headlights

• Rotate the end of the lever to the first detent for parking lights

, the second detent for

headlights

, and the third detent for AUTO.

• When set to AUTO, the system automatically turns the headlights on or off based on ambient

light levels.

O P E R A T I N G Y O U R V E H I C L E

19