beautypg.com

Using the panic alarm, Programming additional transmitters, Battery replacement – Chrysler 2008 Pacifica User Manual

Page 24

background image

Using The Panic Alarm:

To activate the Panic mode while the ignition is OFF press
and release the PANIC button on the transmitter once.
When the Panic mode is activated, the interior lights will
illuminate, the headlamps and parking lights will flash,
and the horn will sound.

To cancel the Panic mode press and release the PANIC
button on the transmitter a second time. Panic mode will
automatically cancel after 3 minutes or if the vehicle is
started and exceeds 15 mph. During the Panic Mode, the
door locks and remote keyless entry systems will func-
tion normally. Panic mode will not disarm the security
system on vehicles so equipped.

NOTE:

When you turn off the panic alarm by pressing

the PANIC button a second time, you may have to be
closer to the vehicle due to the radio frequency noises of
the system.

Programming Additional Transmitters

Refer to SENTRY KEY “Customer Key Programming.”

NOTE:

If you do not have a programmed transmitter,

contact your authorized dealer for assistance.

Battery Replacement

The recommended replacement battery is CR2032 bat-
tery.

NOTE:

Perchlorate Material — special handling may

apply.

See

www.dtsc.ca.gov/hazardouswaste/

perchlorate

NOTE:

Do not touch the battery terminals that are on

the back housing or the printed circuit board.

1. With the transmitter buttons facing down, use a small
screwdriver or similar flat object to pry the two halves of
the transmitter apart. Make sure not to damage the
rubber gasket during removal.

24

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE