Chrysler 2008 Pacifica - Manual (Page 150)

7. Return to the vehicle and press the programmed
HomeLink
௡ button twice (holding the button for 2 sec-
onds each time). If the device is plugged in and activates,
programming is complete.
If the device does not activate, press the button a third
time (for 2 seconds) to complete the training.
NOTE: If you are have any problems, or require assis-
tance, please call toll-free 1–800–355–3515 or, on the
Internet at www.HomeLink.com for information or assis-
tance.
To program the remaining two HomeLink ௡ buttons,
repeat each step for each remaining button. DO NOT
ERASE THE CHANNELS.
Canadian Programming/Gate Programming
Canadian radio-frequency laws require transmitter sig-
nals to
Љtime-outЉ (or quit) after several seconds of
transmission which may not be long enough for
HomeLink
௡ to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to
Љtime-outЉ in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLink
௡ button
while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink
௡
has successfully accepted the frequency signal. The red
HomeLink
௡ indicator will change from a slow to rapid
150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE