Chrysler 2008 Pacifica - Manual (Page 148)

to HomeLink
௡ for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
while training.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1–3 inches (3–8 cm)
from the HomeLink
௡ buttons while keeping the indicator
in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink
௡.
3. Simultaneously press and hold both the chosen
HomeLink
௡ button and the hand-held transmitter button
until the until the red HomeLink ௡ indicator changes from
a slow to a rapid flash rate or the EVIC display changes
from “CHANNEL # TRAINING” to “CHANNEL #
TRAINED.”
Then release both the HomeLink
௡ and hand-held trans-
mitter buttons.
If the EVIC display states “DID NOT TRAIN” repeat
Step 3. If the signal is too weak, replace the battery in the
original hand-held transmitter.
It may take up to 30 seconds, or longer in rare cases. The
garage door may open & close while you train.
NOTE: Some gate operators and garage door openers
may require you to replace Step #3 with procedures
noted in the “Gate Operator/Canadian Programming”
section.
4. Press and hold the newly-trained HomeLink ௡ button.
If the channel has been trained, the EVIC display will
now state “CHANNEL # TRANSMIT.”
If the EVIC display still states “CHANNEL # TRAIN-
ING”
repeat Step 3.
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE