Basic tv connections, Rf coaxial connection, How to set the dvd-i-vcr’s rf output channel – Toshiba SD-V290-S-TU User Manual
Page 12: Audioa/ideo connection, Connections (continued)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections (Continued)
Basic TV Connections
• Make one of the following connections, depending on
the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on the TV using the 75-Ohm Coaxial
Cable supplied (R).
HNote
if you use this connection, tune the TV to the
DVD+VCR’s RF output channel (CH 3 or 4).
How to set the DVD-i-VCR’s RF output channel
1. When the DVD+VCR is turned off, press and hold
CHANNEL A or CHANNEL T on the front panel for
about five seconds.
It will
turn
itself on and “RF 03" or “RF 04” appears
in
the
display window.
2. Press CHANNEL
A
or CHANNEL
T
on the front
panel or CH/TRK (+/-) on the remote control to
change the RF output channel (CH 03 or CH 04).
3. Tum off and on the DVD+VCR.
4. Press the TV CH to 3 or 4 depending on the RF
output channel you had selected.
Now you can watch the DVD+VCR playback on CH3
or CH4 of your TV.
AudioA/ideo connection
f
Connect the DVD/VHS VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using the
video cable supplied (V).
■ Connect the Left and Right DVD/VHS AUDIO OUT
:_ jacks on the DVD+VCR to the audio left/right in
jacks on the TV (At) using the supplied audio
cabies.
HNote
if you use this connection, set the TV's source selector
to VIDEO.
1-14