Toshiba MA-205 - Manual (Page 28)

The MA-205 model can calculate tax using one of three methods of tax
calculation, which can be programmed in the programmable memory. The three
methods are:
1. FULL-BREAK METHOD (COMBINATION OF NON-CYCLIC BREAKS AND CYCLIC BREAKS)
(Maximum 32 breaks programmable)
2. COMBINATION OF NON-CYCLIC BREAKS AND X RATE
(Maximum 32 breaks programmable)
3. % RATE ONLY
CONDITION: After a reset
OPERATION: Mode Lock: SET
Select one of the following three methods to meet your tax status:
SETTING TAX TABLE
1. FULL BREAK METHOD
Non-cycllc Breaks
1) Enter the first break point of price that is non-taxable limit,
and depress LTX/Mj .
2) Enter the next break point of price chat is the limit to collect
the tax amount l(i, and depress ГТХ/М1.
3) Repeat Step 2) above, with alternating each limit price for
collecting tax amount of 2é, 3^, 4¿ ... until the non-cyclic breaks
are all entered.
4) Depress [ST] to end the non-cyclic break entries.
Cyc lie Breaks
1 ) Do the same operation as in Step 1) above, entering each limit
price for each tax amount that increases by \ i , followed by the
[TX/M] key. Enter the last price so that the difference between
the last non-cyclic break price already entered and the last cyclic
one will be a multiple of one dollar ($9.00 maximum). Otherwise,
the tax calculation will not function.
2) Depress [AT/TLI to end the cyclic break entries as well as the
entire tax program.
2, COMBINATION OF NON-CYCLIC BREAKS AND X RATE
Non-cyclie Breaks
1) Do the same operation stated above in 1 from Steps 1) through 4)
of Non-cyclie Breaks.
X Rate
1) Enter the tax percentage rate above the non-cyclic breaks. (The
rate may be entered in maximum 5 digits; 2 digits above the decima1
and 3 digits below the decimal point. For example, to set 4X,
enter "4000".)
2) Depress [AT/TL] to end the percentage rate entry as well as the
entire tax table program.
- 2 5 -