Operating the tv, 1 slide the remote control mode selector to tv, 2 press and hold c!)/l tv – JVC TH-C30 User Manual
Page 15: 3 press enter, 5 release 0/1 tv, Operating the dbs tuner or catv converter, 2 press dbs, 3 press and hold 0/1 vcr/dbs, 4 press enter, Operating external components with the
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Operating external components with the remote control
NOTE
Manufacturers’ codes are subject to change without notice.
Set the codes agiiin after replacing the batteries of the remote control.
Operating the TV
■ To set the manufacturer's code
1
Slide the remote control mode selector
to TV.
2
Press and hold C!)/l TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
Press number buttons (1-9,0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
Manufacturer
Code
Manufacturer
Code
JVC
01»
Samsung
12
Hitachi
t o
Sanyo
13, 14
Magnavox
02
sharp
06
Mitsubishi
03
Sony
07
Pcinasonic
04, 11
Toshiba
08
Philips
15
Zenith
09
RCA
05
* “01” is the initial setting.
5
Release 0/1 TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
■ Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
. Set the remote control mode selector to TV.
The following buttons are available:
0/1 TV:
Turns TV on and off.
TV VOL +/-:
Adjusts the volume.
TV/VIDEO:
Selects the input mode (either TV or
VIDEO).
CH +/-;
Changes the channels.
1 -10, 0, Si0 (100+): Selects the channel.
TV RETURN:
Alternates between the previously selected
channel and the current channel.
NOTE
. The operating buttons may differ depending on manufacturers.
Operating the DBS tuner or
CATV converter
■ To set the manufacturer's code
1
Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold 0/1 VCR/DBS.
Keep the button pressed until step ;> is finished.
4
Press ENTER.
Continued on the next page
12