Harbor Freight Tools Model 98525 - Manual (Page 5)

SKU 98525 For technical questions, please call 1-800-444-3353. Page 5
when servicing a tool, use only b.
identical replacement parts. use
only authorized parts.
use only the lubricants supplied
c.
with the tool or specified by the
manufacturer.
air source
a. never connect to an air
source that is capable of
exceeding 200 pSi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
Never use oxygen, carbon dioxide,
b.
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SaVe tHeSe
inStruCtiOnS.
SYmBOlS and
SpeCiFiC SaFetY
inStruCtiOnS
Symbol Definitions
Symbol property or statement
n
o
No-load speed
Chart continued in next column.
Symbol Definitions
Symbol property or statement
.../min
Revolutions or reciprocation per
minute
pSi
Pounds per square inch of pressure
ft-lb
Foot-pounds of torque
Bpm
Blows per minute
CFm
Cubic Feet per Minute flow
SCFm
Cubic Feet per Minute flow at
standard conditions
npt
National pipe thread, tapered
npS
National pipe thread, straight
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
eye protection.
WARNING marking concerning Risk
of Hearing Loss. Wear hearing
protection.
WARNING marking concerning Risk
of Respiratory Injury. Wear NIOSH-
approved dust mask/respirator.
WARNING marking concerning Risk
of Explosion.
Specific Safety Instructions
The warnings and precautions dis- 1.
cussed in this manual cannot cover
all possible conditions and situations
that may occur. It must be under-
stood by the operator that common
sense and caution are factors which
cannot be built into this product, but
must be supplied by the operator.
WARNING: Some dust created by
2.
power sanding, sawing, grinding, drill-
ing, and other construction activities,
contains chemicals known [to the