Toshiba SD-3960SU - Manual (Page 18)

Interlaced outpuis/inputs (ColorStream®)
Some TVs or monitors are equipped with component video
Inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer, (ex. Y, R-Y, B-Y or Y.
C b , C r )
In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.
Progressive outputs/inputs (ColorStream®Pro)
Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively
scanned video signal. Connecting to these inputs allows
you to view the highest quality pictures with less flicker.
Connecting to an audio system and TV equipped with component video inputs
o
o
Signal Flow
To ANALOG AUDIO OUT
To audio inputs of
the amplifier
o
o
o s s c n
o
r ^
□
Q
v..y . II.....
Audio system
Switching the output signal (interlaced/progressive)
using the remote control
(only when “Progressive” is set to “Enable” fsi))
You can temporarily switch the output signal for better
picture quality.
Press PROGRESSIVE on the remote control.
TV or monitor with
component video inputs
Make the following setting.
On-screen display Select: Page
•’Digital Output”
’’Bitstream"
or
“PCM"
If you connect a progressive TV, set
“Progressive" to “Enable” I
Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the
DVD video piayer away from the tuner and radio.
• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s voiume to a moderate
listening level. Otherwise, high volume sound may damage your hearing as well as the speakers.
• Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power
on, the speakers may be damaged.
19