To operate uh-054 in duplex mode – Uniden UH054A User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The signal coming from your radio is received
by the Repeater station and then retransmitted
at the same time on another channel. This
operation is called "duplexing".
Your UH-054 is designed with the capability to
access and use repeater stations.
Channels 01 through 08 have the option to
operate in Duplex Mode, When any of these
channels are set to operate in duplex mode
during transmission, the UH-054 automatically
sends the signal at a frequency 30 channels
above the original. After transmitting, the radio
reverts back to its original operating frequency.
For example,
(1) CHOI on Duplex Mode will Receive on
CH 01 but Transmit on CH31
(2) CH02 on Duplex Mode will Receive on
CH 02 but Transmit on CH32 etc....
If you transmit on CHOI Duplex mode, you are
actually transmitting on CH31, the repeater
station down-converts your signal and
retransmits on CHOI.
TO operate UH-054 in Duplex Mode
eg. CHOI is being used
^
in your area for
repeater use.
V
n I
U i
Press DUPLEX
momentarity. The DUP
icon appears.
Press DUPLEX again
to deactivate the
duplex operation.
UH-054 will return to
simplex operation.
n I
U I
12