Kenwood KAC-X501F - Manual (Page 6)

B.M.S. (Bass Management System)
o
OWUTlClN/PBaTECtWW
On№CLOSE
u
a
LOWVQLTAOE
i
SS.S.
B.M.S. indicator
If the unit is not going to be operated from the outside:
(D B.M.S. switch
This boosts the bass, focusing mainly on
the frequency setting determined using the
B.M.S. FREQUENCY control.
The bass boost applies only to the B
amplifier.
* (REMOTE) OPEN/CLOSE or
(REMOTE) B.M.S. position:
When the switch is in this position, the
bass is not boosted.
Bass boost Flat (OFF)
Slide panel
Operations using the
OPEN/CLOSE button
• B.M.S. (+6) position:
When the switch is in this position, the
bass is boosted by 6dB.
The B.M.S. indicator glows.
Bass boost +6dB (ON)
Slide pane!
Operations using the
OPEN/CLOSE button
® B.M.S. FREQUENCY control
When the B.M.S. switch is set to the
B.M.S. (+6) position, this control can be
used to adjust the central frequency that
you want to emphasise.
(D OPEN/CLOSE button
Each time you press this button, the slide
panel either opens or closes.
NOTE
• If the sUde panel meets an obstacle while
sliding, the slide operation will be halted. If
this happens, remove the obstacle and then
press the OPEN/CLOSE button again.
• If the center unit power is switched OFF, or
the vehicle engine is switched OFF, while
the slide panel is open, the slide panel will
then close automatically. The next time the
power is turned ON or the vehicle engine is
turned ON, the slide panel will return to its
original open state.
• If the B.M.S. switch setting is changed to
(REMOTE), the slide panel will close in
preparation for remote operation, even if the
EXT.AMP.CONT. terminal is not connected.
ACAUnON
Take care not to allow your finger or any other
object to be trapped by the slide panel while it
is sliding.
6
Enafish