Speaker setting, Positioning the speakers, Preparation – Kenwood DVR-6100 User Manual
Page 54: Speaker level setting, L^c^r^rs^ls^sw
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Speaker setting
Positioning the speakers
Dv h-ouD/Li V R-Ò i
U'lj/uv
h-G 1 GOK (
l
.
To achieve the optimum effects obtainabie with this SURROUND SOUND system, it is important to position the speakers
properly. Refer to the following illustration to find the best location in your room.
Preparation
OPIay a disc marked "Dolby Digital".
GStop the playback.
AUTO/MONO
For this unit, the speaker levels have been set in advance so that the best volume balance is obtained with
standard use.
Initial set values for the speaker level
{
Left Front channel (LchHL)
Center channel (Cch)(C)
Right Front channel (RchHR)
Right Surround channel (RSchHRS)
Left Surround channel (LSchHLS)
Subwoofer(SW)
OdB
OdB
OdB
OdB
OdB
OdB
Reset as follows to match your listening environment.
Speaker level setting
OPress SETUP key for more than 2
seconds
© Press the TRIM (
a
/
t
)
keys to con
trol the speaker level.
TRIM
• After all speakers have been adjusted, operate the
Delay time setting (-SB).
• If you want to quit at this time, press the
ENTER
key.
The test tone is played back from the Left Front speaker.
Adjust the
VOLUME CONTROL
so that it is slightly loud
and fix it there.
"L" Blinks.
TSlSID
-^/ I \G
d
CD □
The speakers will be switched as follows In Intervals of
about 2 seconds.
►L^C^R^RS^LS^SW
Adjust the volume with the TRIM
(
a
/
t
)
keys while the
indicator is flashing so that the volume from all speakers
except the subwoofer (SW) appears the same. Level ad
justment is possible in the range from -10 dB to +10 dB.
As the subwoofer (SW) has a special playback band, nor
mal adjustment Is not possible with the test tone. Please
adjust the subwoofer while listening to actual music. (-Qe])