Kenwood DVR-6100 - Manual (Page 2)

^Introduction
Before applying power
Units are designed for operation as foiiows.
U.S.A. and Canada ............................................... AC 120V only
Australia ................................................................ AC240 V only
i-605/üvF üK (EN)
Caution: Read this page carefully to ensure safe operation.
Europe and U.K. ..................................................... AC 230V only
*Other countries .................... AC 110-120/220-240 Vswitchable
For the United Kingdom *For other countries
Factory fitted mouided mains piug
1. The mains plug contains a fuse. For replacement, use
only a 13-Amp ASTA-approved (BS 1362) fuse.
2. The fuse cover must be refitted when replacing the
fuse in the moulded plug.
3. Do not cut off the mains plug from this equipment. If
the plug fitted is not suitable for the power points in
your home or the cable is too short to reach, a power
point, then obtain an appropriate safety approved
extension lead or adapter, or consult your dealer. If
nonetheless the mains plug is cut off, remove the
fuse and dispose of the plug immediately, to avoid a
possible shock hazard by inadvertent connection to
the mains supply.
IMPORTANT :
The wires in the mains lead are coloured in accordance
with the following code:
Blue : Neutral
Brown : Live
Do not connect those leads to the earth terminal of a
three-pin plug.
Safety precautions
AC voltage selection
The AC voltage selector switch on the rear panel is set
to the voltage that prevails in the area to which the unit
is shipped. Before connecting the power cord to your AC
outlet, make sure that the setting position of this switch
matches your line voltage. If not, it must be set to your
voltage in accordance with the following direction.
AC voltage selector switch
ACIIO-ISOV-V AC220 - 240V'V
r m
Move switch lever to match your line voltage with
a small screwdriver or other pointed tool.
Note:
Our warranty does not cover damage caused by excessive
line voltage due to improper setting of the AC voltage
selector switch.
Caution: Read this page carefully to ensure safe operation.
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SER­
VICING TO QUALIFIED SERVICE PERSONNEL.
A
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRI­
ANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DAN­
GEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT
MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
A
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TQ ALERT
THE USER TQ THE PRESENCE QF IMPQRTANT QPERATING AND MAINTENANCE (SER­
VICING) INSTRUCTIQNS IN THE LITERATURE ACCQMPANYING THE APPLIANCE.
The marking of products using lasers
(Except for some areas)
LASER PRODUCT |
The marking this product has been classified as Class
1. It means that there is no danger of hazardous radia­
tion outside the product.
Location: Back panel