beautypg.com

Plumbing preparation, Ikwarnin, Cautio – Bosch SHE660 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

PLUMBING PREPARATION

Plumbing Preparation

ikWARNIN

m
rt

Scald Hazard

To avoid being scalded, do not perform any work
on a charged hot water line. Serious injury could

result. Only qualified plumbers should perform
plumbing work. Do not attempt any work on the

dishwasher hot water supply plumbing until you
are certain the hot water supply is shut off.

CAUTIO

n

Li

Temperatures required for soldering and sweating
will damage the dishwasher’s base and water inlet
valve. If plumbing lines are to be soldered or
sweated, keep the heat source at least 6 inches
(152.4 mm) away from the dishwasher’s base and
water in let valve.

Hot Water Supply

The hot water heater should be set to deliver
approximately 120“ F {49“ C) water to the dishwasher.
Water that is too hot can cause some detergents to lose

effectiveness. Lower water temperatures will increase run

times. The hot water supply pressure must be between

1 5 - 1 4 5 p s l ( 1 - 1 0 bars).

Hot Water Supply Plumbing
Install an easily accessible shut-off valve (not supplied) in

the hot water supply line, as shown in Figure 6. All solder
connections must be made before the water line is
connected to the dishwasher’s water inlet valve. Water

may also be supplied to the dishwasher by using a

stainless steel braided hose approved for dishwasher use.

Check with your local plumbing supply sources for the
proper hose and 90“ elbow fitting.

NOTE: Regardless of where the hot water supply line
enters the enclosure, position the line 14" (355mm) from

the enclosure’s left side, as shown in Figure 6.

NOTE: Decide whether braided hose or copper tubing will
be used for the hot water supply plumbing, and purchase

the correct type of hot water supply shut-off valve, 90°

elbow, and necessary fittings for the hot water supply
plumbing.

This manual is related to the following products: