Base and toe panel (continyed), Iiwarnin, Final instructions – Bosch SHE660 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Base and Toe Panel/ Final Instructions

BASE AND TOE PANEL (Continyed)

Plastic Base Access Panel and Toe Panel Installation

(SHY66C, SHX99A, SHE66C, SHE99C, SHX57C, and
SHV57C models only)

1 Place the Plastic Base Access Panel under and up the

front bottom panel of the dishwasher, as shown in

Figure 34a.

2 Insert the Plastic Base Access Panel screws into the

Plastic Base Access Panel, as shown in Figure 34b.

Tighten the Plastic Base Access Panel Screws.

3 Place the Cotton Insulation Strip under the unit,

between the bottom of the Plastic Base Access Panel

and the floor, as shown in Figure 34c.

4 Attach the Toe Panel to the Plastic Base Access Panel

using the Toe Panel Screws included in the Toe Panel

Installation Kit. See Figure 34d.

NOTE: You will not use the normal Toe Panel Screws
included in the Dishwasher Installation Kit on these
models.

iiWARNIN

In some conditions, Hydrogen gas can form in a
hot water system that has not been used for
weeks. Hydrogen gas is explosive. Before filling
a dishwasher from a system that has been off for
weeks, run the water from a nearby faucet in a
well ventilated area until there is no sound or
evidence of gas.

FINAL INSTRUCTIONS

1 Energize the dishwasher power supply circuit.

2 Consult the Dishwasher Use and Care Manual, and run

the dishwasher through one complete cycle. If the
dishwasher does not operate properly, refer to the Self

Help section of the Use and Care Manual. If the

dishwasher still does not operate properly, refer to the

Customer Service Section of the Use and Care

Manual.

This manual is related to the following products:

SHE66C