Compaq MP2800 - Manual (Page 9)

Getting Started 9
Part Number: 216023-001 - Writer: Carey Gregg - Saved by: The Integrity Group
Pages: 18 Words: 2766 Saved date: 09/22/0010:37 AM File Name: Ch01.doc
Connecting the Projector to a Portable Computer
1. Rotate the elevator foot to balance the projector.
2. Connect one end of the projector signal cable to the projector
and the other end to the VGA connector ➊B or the DVI
connector ➊A on the portable computer and tighten the screws.
✎ Be sure the signal cable aligns with the connector. Do
not force the cable onto the connector or you may
damage the signal cable or the projector.
3. Connect one end of the power cord ➋ into the back of the
projector, and the other end to an electrical outlet that is easily
accessible and close to the projector. The projector will
automatically be placed into Standby mode.
4. Press the blue Standby button on the top of the projector to turn
on the projector first, then turn on the computer.
✎ For security purposes, this projector has been fitted with a
security lock slot ➌ (located on the left, front side) for use
with a security cable lock that can be purchased separately
at most computer stores.