Aligning the machine – Bosch WFB 1002 User Manual
Page 70
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GB
Aligning the machine
Fig. (D
! The machine must be perfectly level with all
four feet standing on the floor. It must not
wobble.
O Use a spirit level to align the machine on all
sides.
If necessary, correct the height of the ma
chine’s feet.
1. Undo the lock nuts
2. Adjust the height of the feet.
3. Tighten the lock nuts again firmly to ensure
that the feet remain at the same height.
Fig. ®
For the water connection, a standard cold-wa
ter line with a minimum water pressure of 1 bar
is required (with tap full ON, at least 8 litres of
water must flow out in one minute).
If the water pressure exceeds 10 bar, a pres
sure reducing valve must be added.
! Do not connect the machine to the mixer tap
on a pressuretess hot-water heater. If in
doubt, arrange for the machine to be con
nected by a specialist.
! Caution! The hose connections are subject
to the full water pressure; check for leaks
with the tap turned fully ON.
! The filters at the free end of the inlet hose
and at the back of the machine should only
be removed for cleaning purposes.
! To avoid water damage, the tap must be
turned OFF when the machine is not in use.
Í The plastic nuts on the hose connections
should only be tightened by hand.
72