Selecting the wash programme, Starting the programme, Programme sequence – Bosch WFB 1002 User Manual

Page 64: Altering the programme, Switching the machine off, Turn the tap off

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Washing

End of wash programme /
Switching the machine OFF

Selecting the wash programme

1, Turn the programme selector clockwise until

it reaches the required programme (Fig. (§)),

2, Set the temperature selector to the required

temperature,

3, Press the buttons for any additional func

tions that are required.

Starting the programme

1, Make sure that the door is closed,

A safety switch prevents the machine from

operating when the door is open,

2, Press the ’’ON/OFF” button (Fig, ®), The

red ON indicator light illuminates and the

programme starts.

Programme sequence

The position of the programme selector Indi

cates which stage in the wash programme the
machine is currently at.

Altering the programme

Switch off the machine (press the "ON/OFF”
button). Turn the programme selector clock

wise to the new programme. Switch the ma

chine on again.

All programmes end automatically after the

spin cycle.
If the ’’Rinse hold" button has been pressed,

the programme will stop at the final rinse cycle

and the washing will be left in the final rinse

water.

You then have two options:

• remove the washing while it is dripping-wet

• spin the washing

If you want to take the laundry out dripping-

wet:

1, Switch OFF the machine,

2, Set the programme selector to

Pumping

(P).

3, Switch the machine ON again.

The rinse water is pumped out without spin

ning.

If you want to spin the laundry;

O Press the "Rinse hold" button again to re

turn it to its normal position.

The water is then pumped out and the laun

dry is spun.

Switching the machine OFF

1. Press the

’’ON/OFF"

button.

The machine is switched off and the power

indicator light goes out,

2. After approx, 2 minutes you will be able to

open the door and remove the washing.

! Remove any foreign objects (paper clips,

coins, etc.) inside the drum or trapped in the

rubber seal, otherwise there is a danger or

rust occurring.

Leave the door open slightly so that the ma
chine can dry out properly.

3. Reset any buttons that were pressed by

pressing them again.

Turn the tap OFF!

This manual is related to the following products:

WFB 1602