Pioneer F-208RDS - Manual (Page 6)

©6 STANDBY/ON switch
This is the switch for electric power.
ON .....................When set to ON position, power is supplied and
the unit becomes operational.
STANDBY .......... When set to STANDBY position, the main power
flow is cut and the unit is no longer fully operational.
A minute flow of power feeds the unit to maintain
operation readiness.
NOTES:
# The memory will be backed up so long as the power cord is
unplugged.
0 If the power cord is unplugged, the memory will be retained for
several days.
0 When not using the unit fora long period, disconnect the power
cord.
©EON button
Use this to select the desired EON mode, (see page 14)
Each time you press the button, the mode changes as follows.
When receiving AM,valid only when the station name is memorized.
EONTA-^ EON NEWS
----------- Off <---------------
(3)CHARACTER/SEARCH button
When in the Preset Station Tuning mode:
You can use it to input station names manually, (see page 11)
During FM reception:
You can use it to perform Program Type Search, (see page 15)
©DISPLAY MODE button
During FM reception. Use this to switch between display modes.
Each time you press it, the display changes as follows.
RT...................
1
............. Displays RT—> PS
t 1
vl
PS .................. ............. Displays PS or Station name
n I'
PTY
4.
FREQ.............. ............. Displays frequency.
------- ^
Station name
Frequency
When no station name is memorized,the DISPLAY MODE button
becomes invalid.
©Operating Display
©MEMORY button
Use to preset stations. This is also used for FM or AM broadcast
manual station name character selection and for Program Type
Search.
©CLASS button
Use to switch between preset memory classes A to C. In each
class, 10 stations can be memorized using the STATION CALL
buttons, enabling a total of 30 stations to be memorized.
© DIRECT button
When this button is pressed, the STATION CALL buttons function
as ten-key number buttons for direct input of the desired reception
frequency. Press again to cancel this mode.
© TUNING MODE button
Each time you press this button, the TUNING knob's function
changes as follows,
^Manual tuning mode Auto tuning mode—i
--------- Preset station tuning mode <---------------- >
® TUNING knob
Use for tuning. To raise the frequency, turn in a clockwise direction;
to lower the frequency, turn counterclockwise.
AM : For MW,frequency changes in 9 kHz steps.
For LW,frequency changes in 1 kHz steps.
FM : Frequency changes in 50kHz steps.
In the station name input mode, PTY search mode, the TUNING
knob is used to select characters and program types. When
presetting a station or selecting a preset station, you can also turn
this knob to select a desired station number.