beautypg.com

If using an existing vent system, If this is a new vent system, Vent material – Kenmore 8907 User Manual

Page 9: Rigid metal vent, Flexible metal vent, Elbows, Exhaust

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death or

fire.

WARNING:

To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

IMPORTANT: Observe all governing codes and ordinances.

The dryer exhaust must not be connected into any gas vent,
chimney, wall, ceiling or a concealed space of a building.

Please read the following instructions carefully before installing

the dryer. These instructions should be kept for future reference.

If

using an existing vent system

■ Clean lint from the entire length of the system and make sure

exhaust hood is not plugged with lint.

■ Replace any plastic or metal foil vent with rigid or flexible

heavy metal vent.

■ Review Vent system chart. Modify existing vent system if

necessary to achieve the best drying performance.

If this

is a new vent system

Vent material

■ Use a heavy metal vent. Do not use plastic or metal foil vent.

■ 4" (10.2 cm) heavy metal exhaust vent and clamps must be

used.

4"

(10.2 cm) heavy metal exhaust vent

Rigid metal vent

■ For best drying performance, rigid metal vents are

recommended.

■ Rigid metal vent is recommended to avoid crushing and

kinking.

Flexible metal vent

■ Flexible metal vents are acceptable only if accessible for

cleaning.

■ Flexible metal vent must be fully extended and supported

when the dryer is in its final location.

■ Remove excess flexible metal vent to avoid sagging

and kinking that may result in reduced airflow and poor
performance.

■ Do not install flexible metal vent in enclosed walls, ceilings

floors.

Elbows

45° elbows provide better airflow than 90° elbows.

Better

Good

Clamps

■ Use clamps to seal all joints.

■ Exhaust vent must not be connected or secured with screws

or other fastening devices that extend into the interior of the
duct. Do not use duct tape.

3

Clamp

Exhaust

Recommended hood styles are shown here.

A. Louvered hood style

B. Box hood style

The angled hood style (shown here) is acceptable.

An exhaust hood should cap the vent to keep rodents and

insects from entering the home.

(10.2 cm:

Q 2>4"

'**'(6.4 cm)

[BETTER]592-89075-02865A-02_EN.indd 9

2011-03-23 ¿AAЬ 9:49:15