Kenmore 110.8509# - Manual (Page 23)

Auto Dry Preset Cycle Settings Manual Preset Cycle Settings
Auto Dry Cycles
Load Type
Temperature Time*
(Minutes)
HEAVY DUTY
Heavyweight, towels High 44
BULKY/BEDDING
Jackets, comforters,
pillows
Medium 64
JEANS
Denim jeans, jackets
Medium High 54
NORMAL
Corduroys, work clothes
Medium 41
CASUAL
Permanent press,
synthetics
Low 36
DELICATE
Lingerie, blouses,
washable knit fabrics
Extra Low 22
'Estimated Time with Auto Dry Level (Normai) setting. Time will
vary depending on load type and load size.
Manual Cycles Temperature Default Time
Load Type (Minutes)
TIMED DRY High 40
Heavyweight, bulk,
bedspreads, work clothes
EXPRESS DRY™
Small loads High 27
TOUCH UP
Remove wrinkles
Medium High 20
You can customize your cycles by selecting options.
DAMP DRY SIGNAL
(A l 'TO C ycles Oftr)
WFWKLE GUARD
Use Manual Cycles to select a specific amount of drying time and
a drying temperature. When a Manual Cycle is selected, the
Estimated Time Remaining display shows the actual time
remaining in your cycle. You can change the actual time in the
cycle by pressing More Time or Less Time. See “Changing
Cycles, Options and Modifiers.”
Timed Dry
Use this cycle to complete drying if items are still damp after an
Auto Dry Cycle. Timed Dry is also useful for drying heavyweight
and bulky items, such as bedspreads and work clothes.
Lightweight garments, such as exercise wear, can be dried using
Timed Dry on a low temperature setting.
EXPRESS DRY™
Use this cycle for drying small
drying time.
loads or loads that need a short
Touch Up
Use this cycle to help smooth out wrinkles from items, such as
clothes packed in a suitcase or items wrinkled from being left in
the dryer too long.
Damp Dry Signal
Select the Damp Dry Signal to alert you that your clothes are
approximately 80% dry. This is useful when you want to remove
lightweight items in a mixed load to avoid overdrying or remove
partially dry items that may need ironing.
The Damp Dry Signal is useful when drying bedsheets/linens in a
mixed load or large items in the “Bulky/Bedding” cycle. When the
signal goes off, open the door to stop the dryer, rearrange the
load Inside the dryer, close the door and restart the dryer to finish
the drying cycle. Rearranging the load will aid in the drying
process.
For the “Bulky/Bedding” cycle, the Damp Dry Signal is preset to
ON.
NOTE: The Damp Dry Signal is available only with the Auto Dry
Cycles.
WRINKLE GUARD®
WRINKLE GUARD® helps smooth out wrinkles that form when
you cannot unload the dryer promptly at the end of a cycle.
During this option, the dryer stops tumbling and then tumbles
again for a brief period.
■ Press WRINKLE GUARD® to get up to 2V2 hours of heat-free,
periodic tumbling at the end of a cycle.
■ Stop WRINKLE GUARD® at any time by pressing WRINKLE
GUARD® or opening the dryer door.
■ For the Casual Auto Dry Cycle, WRINKLE GUARD® Is preset
to ON. The other Auto Dry Cycles will retain the WRINKLE
GUARD® setting. For example, if you select WRINKLE
GUARD® in the Normal cycle, WRINKLE GUARD® will be on
the next time you select the Normal cycle.
NOTE: If you do not select WRINKLE GUARD®, the dryer stops
after cool down.
23