Kenmore 110.8509# - Manual (Page 18)

3. Remove the 4 screws that hold the hinge to the door. Reverse the door handle
4. Move the 2 large hole screw plugs to the opposite side and
insert in the original screw holes.
A.
A. Hinge screws
B. Hole screw plugs
5. Move hinge to the other side and reattach with the 4 screws
removed in Step 3.
6 . Reverse the plastic cover. Slide it up over the inner door
assembly edge and gently snap into place.
1 .
2 .
Place the outer door assembly face down on work space.
Remove the 2 screws that hold the door handle and the
2 screws holding the hole plugs. If hole plugs do not easily fall
out after screws are removed, insert a small screwdriver into
the holes and gently push the plugs out.
A. Door handle
B. Hole plugs
3. Move the door handle to the other side and reattach with the
2 screws removed from the door handle in Step 2.
4. Move the hole plugs to the new hinge side and attach with
the 2 screws removed from the hole plugs in Step 2.
Reinstalling the door
1. Check for fingerprints on the glass. Clean the glass if
necessary.
2. Place the inner door assembly into the outer door assembly.
Align the hinge cover and hinge in the openings on each side.
To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge.
3. Reassemble the inner and outer door assemblies with the
6 screws.
7. Set the inner door assembly aside.
18